Active Unanswered
Exhaust holes in '59 Continental 18'6"
Moderators: Don Ayers, Al Benton, Don Vogt
-
- Posts: 55
- Joined: Thu Aug 18, 2011 12:10 pm
- Location: St. Louis Metropolitan Area
- Contact:
Exhaust holes in '59 Continental 18'6"
I'm getting ready to drill the exhaust holes in the new transom of my '59 Continental. I notice that the chrome trim rings (outside) fit up under the water molding and there are small indentations where they fit. If I use the exact former locations my exhaust holes will be a bit offside on the port side. Any specifications or recommendations on this? Thanks.
- Don Danenberg
- Posts: 181
- Joined: Fri Nov 18, 2005 9:30 pm
- Location: Manistee, MI
- Contact:
Re: Exhaust holes in '59 Continental 18'6"
' Exact Former Locations' ?
The Factory understood where "plumbing-pipe" Linkages might throw-off design-lines?
The "Workers" were not imbued with design parameters?
They were NOT the perfection you seek?
The Factory understood where "plumbing-pipe" Linkages might throw-off design-lines?
The "Workers" were not imbued with design parameters?
They were NOT the perfection you seek?
-
- Posts: 55
- Joined: Thu Aug 18, 2011 12:10 pm
- Location: St. Louis Metropolitan Area
- Contact:
Re: Exhaust holes in '59 Continental 18'6"
Thank you Dan....I'm going with the original holes!!!! Appreciate the quick response
Who is online
Users browsing this forum: No registered users and 14 guests