Page 1 of 1
Exhaust holes in '59 Continental 18'6"
Posted: Sun Apr 22, 2018 12:44 pm
by gallagh59
I'm getting ready to drill the exhaust holes in the new transom of my '59 Continental. I notice that the chrome trim rings (outside) fit up under the water molding and there are small indentations where they fit. If I use the exact former locations my exhaust holes will be a bit offside on the port side. Any specifications or recommendations on this? Thanks.
Re: Exhaust holes in '59 Continental 18'6"
Posted: Sun Apr 22, 2018 9:00 pm
by Don Danenberg
' Exact Former Locations' ?
The Factory understood where "plumbing-pipe" Linkages might throw-off design-lines?
The "Workers" were not imbued with design parameters?
They were NOT the perfection you seek?
Re: Exhaust holes in '59 Continental 18'6"
Posted: Mon Apr 23, 2018 5:05 pm
by gallagh59
Thank you Dan....I'm going with the original holes!!!! Appreciate the quick response