Active Unanswered
Distributor IGW-4149A Parts
Moderators: Don Ayers, Al Benton, Don Vogt
Distributor IGW-4149A Parts
I am replacing tune up parts in a IGW-4149A distributor. I am unable to find the the insulating bushing and washers that insulate the primary wire stud that goes through the base. Are these parts sourced or is there a DIY procedure?
Re: Distributor IGW-4149A Parts
I was able to use a flanged nylon bushing and nylon washer from hardware. To insulate the points spring strip, I cut a strip from a poly bottle and drilled a hole at one end.
Who is online
Users browsing this forum: No registered users and 2 guests