Page 1 of 1

Cockpit floor stain

Posted: Thu May 17, 2018 1:05 am
by SAMBA
I am refinishing the floor of the aft cockpit on my 1953 34' Sedan Cabin Cruiser. Obviously not mahogany; as I understand it, the floor material is spruce or fir? Down to bare wood now. 2 questions- Was there a stain on this wood, or was it just varnish over bare wood? After stripping but before sanding, it looks like just bare wood (that is, it did not appear that there was stain on the wood). Second, on a floor like this, is it best to caulk the seams before or after varnishing? Looks like the previous varnish was applied OVER the caulked seam.
Thanks, Dan

Re: Cockpit floor stain

Posted: Thu May 17, 2018 6:38 am
by Captain Nemo
Cockpit decking on cruisers were either douglas fir or teak, the difference is obviously the teak is the much harder of the two. Neither was stained. I varnished over the caulking because I wanted to tone down the seams for a patina look, just a preference.
I would post a picture but it appears I no longer can.

Re: Cockpit floor stain

Posted: Thu May 17, 2018 11:58 am
by SAMBA
Thanks so much. Mine is thus Doug Fir, definitely not teak. Will varnish over the caulk as well. Thanks for backing up my leanings with experience; hate to do these things twice!
Dan

Re: Cockpit floor stain

Posted: Sun May 20, 2018 2:20 pm
by Bilge Rat
I second the varnish over the white seams. Knocks down the bright white and gives it a vintage look, kind of like the aged white binding on a Gibson guitar it just looks right to me.