I recently purchased a new trailer and need to adjust some of the bunks to fully support my 18' Riviera hull.
My question is:
In case I have slight warping in the hull, I want to make sure my new trailer bunks are set right where they need to be. What's the best way to go about this to ensure the trailer bunks are setup correctly and supporting the hull properly ?
thanks, JH
Active Unanswered
Setting Up Bunks On a New Trailer
Moderators: Don Ayers, Al Benton, Don Vogt
-
- Posts: 9
- Joined: Mon Jun 18, 2018 6:16 am
- Contact:
Re: Setting Up Bunks On a New Trailer
Your best bet is to lift the boat with an overhead hoist structure and then lower it close to the trailer and adjust the bunks with the hull right there. After that lower onto the trailer and see if you have any gaps between the hull and bunks and make some final adjustments to eliminate them.
You should have at least a couple inches of bunk aft of the transom when in the final position on the trailer.
Mark
You should have at least a couple inches of bunk aft of the transom when in the final position on the trailer.
Mark
1953 CC Rocket Runabout "Rocket Man"
-
- Posts: 9
- Joined: Mon Jun 18, 2018 6:16 am
- Contact:
Re: Setting Up Bunks On a New Trailer
Mark,
My bunks are close but I want to make sure "If" my hull is warped at all, that I can try to correct it as mush as possible by setting them up where the factory shape exactly was.
Does anyone have plans for the 18' Riviera ? I don't think the mariners museum does.
My bunks are close but I want to make sure "If" my hull is warped at all, that I can try to correct it as mush as possible by setting them up where the factory shape exactly was.
Does anyone have plans for the 18' Riviera ? I don't think the mariners museum does.
Who is online
Users browsing this forum: No registered users and 3 guests