Before changing my original ship/shore switch to a breaker panel, all my lights and outlets worked. I had two original wire casings going to AC source- one from each side.
At the time, I assumed one was outlets and one was lights. Turns out they're both outlets- one for each side. The light fixture wiring goes into a collar and into the helm. It then merges into a large harness. I don't see any leads coming out to heat up at a breaker. I can't figure out how they were heated up prior to changing the breaker panel.
I'm going to be installing new wiring w/ ground and would like to route as original, but where do the wires emerge from the harness??? I don't want to cut the harness open. Suggestions? Thoughts?
Active Unanswered
AC Cabin Lights
Moderators: Don Ayers, Al Benton, Don Vogt
Who is online
Users browsing this forum: No registered users and 3 guests