Active Unanswered
Bad coil?
Moderators: Don Ayers, Al Benton, Don Vogt
-
- Posts: 61
- Joined: Tue Jan 25, 2011 8:02 am
- Contact:
Bad coil?
Having just been towed back home for the second time this year was not how I wanted to start my vacation. My 1941 Custom with M engine starts and runs great when cruising but then dies when the engine is warm and idling. It will cough a couple of times before dying but once it dies it will not start until the engine is cold again.
I once had a 1940 Ford 9N tractor that had a coil that went bad and it did the same thing so I am thinking coil - anyone else have this happen?
I once had a 1940 Ford 9N tractor that had a coil that went bad and it did the same thing so I am thinking coil - anyone else have this happen?
-
- Posts: 61
- Joined: Tue Jan 25, 2011 8:02 am
- Contact:
Re: Bad coil?
I probably just answered my own question. I just went to check the engine and while the engine temp. Is now less than 100f the coil is scorching hot. The engine has been converted to 12v so what replacement coil should I be looking for?
-
- Posts: 2092
- Joined: Thu Dec 29, 2005 10:41 pm
- Location: Powhatan Courthouse Virginia
- Contact:
Re: Bad coil?
I can't specify a coil...but if that thing is converted as you mention...maybe you need a coil resistor if using an old style 12v coil....some coils have that built in...but others require the seperate ceramic and wire resistor...not having that working right causes wierd problems usually noticable at throttle up though???
John in Va.
John in Va.
1980 Fairchild Scout 30
19?? custom Argentine Runabout 16'
1954 Whirlwind deluxe dual ckpt 16'
1921 Old Town Charles River 17' (founding Captain, James River Batteau Festival)
19?? custom Argentine Runabout 16'
1954 Whirlwind deluxe dual ckpt 16'
1921 Old Town Charles River 17' (founding Captain, James River Batteau Festival)
-
- Posts: 61
- Joined: Tue Jan 25, 2011 8:02 am
- Contact:
Re: Bad coil?
After it sat for a couple of hours it fired right back up. Since I have had this boat (three years) it has run flawlessly and nothing was changed over the winter which makes it confusing. I will pull the coil today to see what it is.
Re: Bad coil?
Do you have a Pertronix ignition in your distributor?
-
- Posts: 61
- Joined: Tue Jan 25, 2011 8:02 am
- Contact:
Re: Bad coil?
No. After the first time the engine died I replaced the cap, rotor, points and condenser that I got from Jim Staib and it ran great at the dock. It only died when idling after running at half throttle for about 20 minutes.
Re: Bad coil?
Sure points to a coil.
Jim Staib
www.finewoodboats.com
1947 Penn Yan 12' Cartopper WXH474611
1950 Chris-Craft 22' Sportsman U-22-1532
1957 Chris-Craft 26' Sea Skiff SK-26-515
1968 Century 17' Resorter FG-68-174
www.finewoodboats.com
1947 Penn Yan 12' Cartopper WXH474611
1950 Chris-Craft 22' Sportsman U-22-1532
1957 Chris-Craft 26' Sea Skiff SK-26-515
1968 Century 17' Resorter FG-68-174
Re: Bad coil?
Since you still have points. Go to NAPA and get a 12 volt internal resister coil. Buy the top of the line.
All the other auto parts stores sell coils that are junk.
All the other auto parts stores sell coils that are junk.
Re: Bad coil?
You want NAPA number IC14
-
- Posts: 61
- Joined: Tue Jan 25, 2011 8:02 am
- Contact:
Re: Bad coil?
I just put a new Napa IC14 coil on and it fired right up but the real test will come with the test drive. I will need to wait until I get a buddy with a chase boat to follow me.
-
- Posts: 2092
- Joined: Thu Dec 29, 2005 10:41 pm
- Location: Powhatan Courthouse Virginia
- Contact:
Re: Bad coil?
I am telling you guys...those resistors in or around the coil can, when failed, seem like any number of seemingly unrelated problems. Their whole purpose is to keep from overloading the points at max electrical delivery at while cranking....or at least that is the theory...??????.real gremlins...and coupled with bad and phony repro parts... = real nightmare.
John in Va.
John in Va.
1980 Fairchild Scout 30
19?? custom Argentine Runabout 16'
1954 Whirlwind deluxe dual ckpt 16'
1921 Old Town Charles River 17' (founding Captain, James River Batteau Festival)
19?? custom Argentine Runabout 16'
1954 Whirlwind deluxe dual ckpt 16'
1921 Old Town Charles River 17' (founding Captain, James River Batteau Festival)
Re: Bad coil?
The IC 14 is an internally resister coil.
So no external resister needed.
So no external resister needed.
Re: Bad coil?
Whether the coil comes with the resistor internally or you use an external ballast resistor, the resistor will get hot in use. When it's in the coil, the coil will be too hot to touch after running a while. An external ballast resistor is encased in a ceramic housing for a very good reason, it will normally get hot in use. Either style can intermittently fail and magically start working again when cooled down. I always carry 2 spare coils on board to save the day and MAYBE prevent the tow of shame back to the dock.
1966 Lyman Cruisette 25 foot "Serenity Now!"
1953 Chris Craft Sportsman 22 foot "Summerwind"
1953 Chris Craft Sportsman 22 foot "Summerwind"
-
- Posts: 61
- Joined: Tue Jan 25, 2011 8:02 am
- Contact:
Re: Bad coil?
I just got back from our sea trial and everything ran great so thanks to everyone for their input. I do agree that carrying a backup set of ignition parts and coil will be part of my protocol now.
-
- Posts: 61
- Joined: Tue Jan 25, 2011 8:02 am
- Contact:
Re: Bad coil?
Also I noticed that while the new coil was quite warm to the touch it was far cooler than the old coil. That leads me to believe the old coil was “fried”.
Re: Bad coil?
Glad to hear the problem appears to be solved. The fix is also quite reasonably cheap and easy to change out the bad one too.
1966 Lyman Cruisette 25 foot "Serenity Now!"
1953 Chris Craft Sportsman 22 foot "Summerwind"
1953 Chris Craft Sportsman 22 foot "Summerwind"
Re: Bad coil?
Glad to hear the problem is solved!
FYI: I was always taught that the reason for a coil failing when hot, but working again when cooled is because it is just what it says it is. A coil of wire inside. If the wire has an open in it the flow of electrons will jump the gap when cold and close together (maybe even touching), but as the coil heats up the whole thing (inside) expands and the gap in the broken wire gets larger until the electrons can no longer jump that gap thus "No Spark". Once the coil cools down and the gap becomes small enough the electrons will flow again and vwolah "Spark". Just like magic.
FYI: I was always taught that the reason for a coil failing when hot, but working again when cooled is because it is just what it says it is. A coil of wire inside. If the wire has an open in it the flow of electrons will jump the gap when cold and close together (maybe even touching), but as the coil heats up the whole thing (inside) expands and the gap in the broken wire gets larger until the electrons can no longer jump that gap thus "No Spark". Once the coil cools down and the gap becomes small enough the electrons will flow again and vwolah "Spark". Just like magic.
Troy in ANE - Former President CCABC
1957 CC 21' Continental "Yorktown" (Mom's boat)
https://www.chris-craft.org/boats/22625/
1985 Formula 242LS "Gottago"
1991 Formula 36PC "Band Aids"
Life Is Too Short To Own An Ugly Boat
1957 CC 21' Continental "Yorktown" (Mom's boat)
https://www.chris-craft.org/boats/22625/
1985 Formula 242LS "Gottago"
1991 Formula 36PC "Band Aids"
Life Is Too Short To Own An Ugly Boat
Re: Bad coil?
I think Troy's on to the magic, but I think its more like witchcraft.
1966 Lyman Cruisette 25 foot "Serenity Now!"
1953 Chris Craft Sportsman 22 foot "Summerwind"
1953 Chris Craft Sportsman 22 foot "Summerwind"
Re: Bad coil?
"vwolah". Interesting spelling of viola. What kind of Frenchman are you ? Did you graduate the Matt Smith spelling academy ?
Mark
Mark
1953 CC Rocket Runabout "Rocket Man"
Re: Bad coil?
Precisely!
Matt and I spell finetically. Speaking of which why is that word spelled with a ph? Isn't that against the whole concept?
Matt and I spell finetically. Speaking of which why is that word spelled with a ph? Isn't that against the whole concept?
Troy in ANE - Former President CCABC
1957 CC 21' Continental "Yorktown" (Mom's boat)
https://www.chris-craft.org/boats/22625/
1985 Formula 242LS "Gottago"
1991 Formula 36PC "Band Aids"
Life Is Too Short To Own An Ugly Boat
1957 CC 21' Continental "Yorktown" (Mom's boat)
https://www.chris-craft.org/boats/22625/
1985 Formula 242LS "Gottago"
1991 Formula 36PC "Band Aids"
Life Is Too Short To Own An Ugly Boat
Re: Bad coil?
A spark coil Ceases to work properly when it gets warm because of something known as the Curie effect.
A spark coil is a transformer basically. It has a primary side which is a coil of wire and a secondary side which is also a coil of wire. The secondary side has many more turns of wire than the primary so the voltage can be stepped up from battery voltage to approximately 25,000 V. The primary and secondary are coupled together buy an iron core. When current passes through the primary it magnetize the core.
When the current ceases in the primary The magnetic field in the iron induces A current in the secondary causing your spark. So you have a change of form of energy in the coil. It goes from electrical to magnetic and back to electrical. Without the magnetic field you would lose an extreme amount of efficiency of coupling the primary to the secondary. If a coil gets hot for whatever reason and there are numerous the iron becomes hot. Simply put the Curie effect makes it harder or impossible to magnetize iron at higher temperatures. So as the temperature of the coil goes up what we’re really concerned about is the temperature of the iron core. If you can’t easily magnetize the iron core you can’t transform the current in the primary to induce a current in the secondary.
A spark coil is a transformer basically. It has a primary side which is a coil of wire and a secondary side which is also a coil of wire. The secondary side has many more turns of wire than the primary so the voltage can be stepped up from battery voltage to approximately 25,000 V. The primary and secondary are coupled together buy an iron core. When current passes through the primary it magnetize the core.
When the current ceases in the primary The magnetic field in the iron induces A current in the secondary causing your spark. So you have a change of form of energy in the coil. It goes from electrical to magnetic and back to electrical. Without the magnetic field you would lose an extreme amount of efficiency of coupling the primary to the secondary. If a coil gets hot for whatever reason and there are numerous the iron becomes hot. Simply put the Curie effect makes it harder or impossible to magnetize iron at higher temperatures. So as the temperature of the coil goes up what we’re really concerned about is the temperature of the iron core. If you can’t easily magnetize the iron core you can’t transform the current in the primary to induce a current in the secondary.
Who is online
Users browsing this forum: No registered users and 5 guests